WDTech RA Config 1.2b3 allows you to customise your WDTech RA Extension or Application settings. In order to configure your WDTech RA, follow these simple steps:
1. Open a un-loaded Extension or Application (must not be used at the time you open it)
2. Configure your settings, the TCP port is the port you will use in the Telnet terminal to connect to the computer. The default one is 550. Make sure you keep your system password in a safe place.
3. Press the 'Configure' button when your settings are done. You can freely mutate anytime your Extension into an Application or your Application into an Extension using the Mutate button.
4. Quit the Config application, you are done configuring your WDTech Remote Admin Extension/Application.
If you registered WDTech RAE, enter the serial number that was given to you when you registered into the Serial Number field and press register, the application will then be registered.
For those who cannot use this Config application for any reasons, it is possible to manually edit the resources using a resource editor, all the settings are in the 'data' resource (not 'DATA') under ids 1,2 and 3.
